ARB
Titanium
- Joined
- Dec 7, 2002
- Location
- Granville,NY,USA
I am thinking about converting our stick tool lathe over to Capto or Kenny KM. I may not do the whole turret but I'm thinking hard about half of it.
Up until now most of our parts let us run with the same tool package in the machine all the time. I have always done the change overs so if something had to switched I could just handle it.
Now I need to get the change over bit off my plate. I really want to simplify things to help cut down on possible crashes and bad parts. Not to mention set-up time.
What pitfalls should I look for?
Pros and cons of each system????
Other options??
Adam
Up until now most of our parts let us run with the same tool package in the machine all the time. I have always done the change overs so if something had to switched I could just handle it.
Now I need to get the change over bit off my plate. I really want to simplify things to help cut down on possible crashes and bad parts. Not to mention set-up time.
What pitfalls should I look for?
Pros and cons of each system????
Other options??
Adam