Wade C
Stainless
- Joined
- Jul 21, 2004
- Location
- Wiggins CO. USA
Anyone know if its possible with the Okuma LC10 with OSP3000L control? I can not find any reference in the book to it. IF the control wont handle it... whats the possibility that the start point for threads (as far as rotation) is always the same, that if the machine wont do it itself, I could do a single lead thread, and then rotate the part 108 degrees and locate it to the exact same Z base point? AM I crasy and just too big of a dreamer? Im wanting to do .613" x 44tpi doule lead threads.
Thanks!
Wade
Thanks!
Wade