Follow along with the video below to see how to install our site as a web app on your home screen.
Note: This feature may not be available in some browsers.
Largest Manufacturing Technology Community on the Web
Stay Connected:
Error code f438 on startup. Hitachi Seiki 23
- Thread starter saxen
- Start date
- Replies 9
- Views 2,819
Hello
check the incoming power - that is stating the motor current is too high. Normally its an issue with the converter, not the motors, but you can start there to be sure. Are there any alarms / LED's on the drives themselves?
John
check the incoming power - that is stating the motor current is too high. Normally its an issue with the converter, not the motors, but you can start there to be sure. Are there any alarms / LED's on the drives themselves?
John
Hello. We have problems whit one of our lathes. error code (f438) at boot .
If we reboot several times (100+ times) it can fire up. Then it works until you turn it off. but now it wont work at all.
any suggestions?
Is this a HT32 or a CA23 Hicell - also is that alarm a "6" or a ".6" (6 with dot) cant tell from the pic - let me know
John
John
its a ca23-2. the alarm is a 6
View attachment 218134
View attachment 218135
the incoming Power is ok
View attachment 218134
View attachment 218135
the incoming Power is ok
Looks like you have an issue with your servo drive which is causing alarms for the 2 Axis
