Was getting 2023 and 2024 alarms intermittently and they have now gotten to the point where I practically cannot run the machine.
I have only gotten 2024 a couple times:
I get 2023 on a regular basis. I frequently cannot get a tool to change unless I unscrew the prox sensors clear the error and then screw the prox's cables back in. Typically when I get this error, both prox's are made, and I can only get the machine to index if I unscrew both. I took a picture of the prox switches, but the board doesn't like it!
The machine is a Bridgeport Interact 720F. It has a 20 tool carousel changer, which is pneumatic driven over and up/down.
Anyone have any advise on tracking this down and diagnosing what the issue is?
I have only gotten 2024 a couple times:
I get 2023 on a regular basis. I frequently cannot get a tool to change unless I unscrew the prox sensors clear the error and then screw the prox's cables back in. Typically when I get this error, both prox's are made, and I can only get the machine to index if I unscrew both. I took a picture of the prox switches, but the board doesn't like it!
The machine is a Bridgeport Interact 720F. It has a 20 tool carousel changer, which is pneumatic driven over and up/down.
Anyone have any advise on tracking this down and diagnosing what the issue is?