HelicalCut
Stainless
- Joined
- Apr 9, 2007
- Location
- Melbourne Australia
I just tried to backup the parameters on a lathe with Fanuc 10t controller, using hyperterminal and a cable with hardware flow control. Cable measures OK and it has the fanuc 6, 8, 20 pins joined and a loopback test on both the pc and end of the cable confirms the pc side of the comms works.
On the controller side I am not sure what I have, there is a db25 socket on the back of the MDI/CRT box which I am using. The settings/params/punch/all operates with no alarms but I get nothing on the pc terminal.
The parameters on the controller are:
5000 0 0 0 0 0 0 0 0
5001 RS232 DVC SLCT 7
5002 RS232 C2 5
5003 RS232 C3 5
5011 ASP33/43 0
5013 RS422 0
at 5110 - 5132 there are RS232 comms parameters for DVC 1,2 and 3
DVC1 type is 3 and the rest are type 2
stop bits 2, baud rate 10
I have the pc set for E,7,2 and 4800 baud
There is an option board in the controller A16B-1210-350 with no cables plugged in.
I may have the comms on the controller set up wrong does anybody know where the RS232 port is on this controller,what parameters it should have and how to direct the parameter dump to the appropriate port? I have searched for information on this but the set up's appear different to mine.
On the controller side I am not sure what I have, there is a db25 socket on the back of the MDI/CRT box which I am using. The settings/params/punch/all operates with no alarms but I get nothing on the pc terminal.
The parameters on the controller are:
5000 0 0 0 0 0 0 0 0
5001 RS232 DVC SLCT 7
5002 RS232 C2 5
5003 RS232 C3 5
5011 ASP33/43 0
5013 RS422 0
at 5110 - 5132 there are RS232 comms parameters for DVC 1,2 and 3
DVC1 type is 3 and the rest are type 2
stop bits 2, baud rate 10
I have the pc set for E,7,2 and 4800 baud
There is an option board in the controller A16B-1210-350 with no cables plugged in.
I may have the comms on the controller set up wrong does anybody know where the RS232 port is on this controller,what parameters it should have and how to direct the parameter dump to the appropriate port? I have searched for information on this but the set up's appear different to mine.