G-Code out-put form Hiedenhain 415 ??

machine1medic · Jan 14, 2009

I'm swamped picking up 5-face operation on our new SNK bridge-mill.
Fanuk 31i , and the SNK's abillity to run a face-on prog
in any aspect is awesome. We have a very urgent job to take from
Heidenhain over to the SNK.

A while back I had time to brouse our 425 manual.....thought I read
that it could spit-out a G-code file, we could then chop-up and
run through Master-Cam, instead of an entirely fresh effort.

I don't have a minute to waste, !! Did I read correctly?
If so it's worth doubling back into the manual.....to try it.

Thanks in advance for any input..............
M1M

Hansdie · Jan 15, 2009

I don't believe you can convert from Heidenhain to G-code on this model, only the old TNC151 or 155 would convert depending on what mode you were in.
But there are programs out there that can convert between the 2.
Let me know if you need it done and I'll do it for you.

machine1medic · Jan 15, 2009

Hansdie said:
I don't believe you can convert from Heidenhain to G-code on this model, only the old TNC151 or 155 would convert depending on what mode you were in.
But there are programs out there that can convert between the 2.
Let me know if you need it done and I'll do it for you.

That's an extremely kind offer, I'll mention it to our younger lead-man who understands the linking of this tired old Soraluce (Danobat).
Even the out-put port is troublesome, but I think he has this prog backed up on a lap-top.

Many thanks..........and regards.

M1M

Search

Largest Manufacturing Technology Community on the Web

Search

G-Code out-put form Hiedenhain 415 ??

machine1medic

Titanium

Hansdie

Hot Rolled

machine1medic

Titanium

Similar threads