gpettit
Plastic
- Joined
- Aug 30, 2012
- Location
- United States
Hi,
I have a Fanuc Oi-TD control running in manual guide mode. I have just a simple g-code program with a G1900 blank listed at the top. When I simulate the toolpath (SIMLAT) everything works as expected; however, when I run the machine draw (MCHDRW) while cutting the part, the toolpath is not scaled correctly relative to the blank. Does anyone know how to fix this? Please see attached images:
Thanks,
Greg
SIMLAT
MCHDRW
I have a Fanuc Oi-TD control running in manual guide mode. I have just a simple g-code program with a G1900 blank listed at the top. When I simulate the toolpath (SIMLAT) everything works as expected; however, when I run the machine draw (MCHDRW) while cutting the part, the toolpath is not scaled correctly relative to the blank. Does anyone know how to fix this? Please see attached images:
Thanks,
Greg
SIMLAT
MCHDRW
