sputnikprecision
Aluminum
- Joined
- Mar 21, 2007
- Location
- Malta- Europe
Hello,
We are running programs on an 18T FANUC Control on a Lathe
at the end of program, the machine will display 5010 ALARM END OF RECORD.
It is being used without a barfeeder.
The program ends with M05.
If I end by M99 or M02, program will restart by itself at the end.
I do not want it to do so.
When using the same commands to end a FANUC OT control, never have a problem.
Somebody suggests the correct way?
We are running programs on an 18T FANUC Control on a Lathe
at the end of program, the machine will display 5010 ALARM END OF RECORD.
It is being used without a barfeeder.
The program ends with M05.
If I end by M99 or M02, program will restart by itself at the end.
I do not want it to do so.
When using the same commands to end a FANUC OT control, never have a problem.
Somebody suggests the correct way?