Do I have to enact a M29 prior to a G84?
This is on a VMX24 (new and uncrashed) and I 'd like to keep it that way
Hence the reason for the dumb question/s.
Also, the manual reads as though I should program feed with a IPM, instead of a IPR?
So, for a 1/4x20 running at 1000rpm, I would write my programs to say F50. ipm, instead of F0.05" per rev???
Is this the case?
Thanks,
Doug.
This is on a VMX24 (new and uncrashed) and I 'd like to keep it that way
Hence the reason for the dumb question/s.
Also, the manual reads as though I should program feed with a IPM, instead of a IPR?
So, for a 1/4x20 running at 1000rpm, I would write my programs to say F50. ipm, instead of F0.05" per rev???
Is this the case?
Thanks,
Doug.