huskermcdoogle
Stainless
- Joined
- Nov 11, 2005
- Location
- South Texas
I was trying to post a program to a Hardinge Cobra Lathe
Fanuc 21-T Controller
It gives an Error 010 Improper G-Code
I have no idea what this means but I will post the first part of the code and see if any of you think you know what is wrong.
it stops at the G50 S3600
%
O0000
G20
(PROGRAM NAME - HELP DATE=DD-MM-YY - 04-01-06 TIME=HH:MM - 17:32)
(TOOL - 1 OFFSET - 1)
(LROUGH OD ROUGH RIGHT - 80 DEG. INSERT - CNMG-432)
G0T0101
G97S216M13
G0G54X3.5341Z.11
G50S3600
G96S200
G99G1Z-2.84F.01
X3.7339Z-3.0141
X3.8753Z-2.9434
G0Z.11
this is obviously abreivated but it makes it no further than the G50 when you go back to edit.
No idea that is wrong. Compared it to other programs in the memory that i have ran in the past and see no differences up to that point.
Fanuc 21-T Controller
It gives an Error 010 Improper G-Code
I have no idea what this means but I will post the first part of the code and see if any of you think you know what is wrong.
it stops at the G50 S3600
%
O0000
G20
(PROGRAM NAME - HELP DATE=DD-MM-YY - 04-01-06 TIME=HH:MM - 17:32)
(TOOL - 1 OFFSET - 1)
(LROUGH OD ROUGH RIGHT - 80 DEG. INSERT - CNMG-432)
G0T0101
G97S216M13
G0G54X3.5341Z.11
G50S3600
G96S200
G99G1Z-2.84F.01
X3.7339Z-3.0141
X3.8753Z-2.9434
G0Z.11
this is obviously abreivated but it makes it no further than the G50 when you go back to edit.
No idea that is wrong. Compared it to other programs in the memory that i have ran in the past and see no differences up to that point.