New to me fadal vmc15, has t818e transformer running on 480v. Machine turns on fine, spindle winds up and runs great, control works, estop works, etc. The issue I am having is whenever I enter jog mode I get a servo amplifier fault (error #18) on the axis that is selected. This alarm moves with whatever axis is currently selected to jog. I can continue to reset the alarm and eventually It will allow me to jog the axis for a random amount of before I get the alarm again. In between these servo amplifier fault alarms I have had a motor overload error (cant remember error #) a few times on the axis that is selected, however when I got this alarm I did not get the Amplifier alarm with it, just the motor overload alarm. I have checked my +12v, -12v and 5v and all were right on the money. There is no binding on any of the axis, I can turn them by hand smooth as butter. I have been able to cold start the machine in between these issues, I also was able to make the machine "runaway" by disconnecting 2 of the servo amps. Im completely stumped, my electrician is completely stumped, and Ive searched the forums up and down trying to figure this out but still no luck. Any help would be greatly appreciated and will probably keep me out of the asylum