Hello Guys

This is the first few days of playing around with this Fanuc 18i-TB control with EZ Guide i installed on it. I have created my first program an all seems good until it is simulated, the program runs until it reads the first sub program an gets to the G1456 at the end of sub then alarms out with a 078.

Could any of you fine gentle men help me with this problem??

2006 Doosan 2000sy

Thanks Mike Roy in Canada

Mike, P.M. me your e-mail, I have the manual guide i manual in pdf I can send you.

nomgis, is your manual for all manual guide i lathes? We have a Oi-TD with manual guide i that I haven't been using because I just don't have much time to play and learn it, but a manual would make a world of difference.

P.M. me your info and I will send it to you.