Good morning all.
I'm trying to help a guy out with some simple parts he needs setup on his VMC. It is a Matsuura mill with Yasnac i80 controller.
I need basically a step by step for setting up a G54 and measuring tools.
The guy that used to run the machine has fallen ill and can't help so I'm completely new to this machine.
Also, when in MDI I can't seem to get it to run a simple G00 or G01 command either. Do I need to press a button after each x, y, or G-code? Or can I just type it in no spaces or anything as I do on our older Haas machine.
I'm trying to help a guy out with some simple parts he needs setup on his VMC. It is a Matsuura mill with Yasnac i80 controller.
I need basically a step by step for setting up a G54 and measuring tools.
The guy that used to run the machine has fallen ill and can't help so I'm completely new to this machine.
Also, when in MDI I can't seem to get it to run a simple G00 or G01 command either. Do I need to press a button after each x, y, or G-code? Or can I just type it in no spaces or anything as I do on our older Haas machine.