1Latheman
Plastic
- Joined
- Jan 2, 2018
- Location
- York, Pa USA
The shop I work for purchased an AX15Z lathe with a Fanuc 10T control and supposedly the batteries were good.
Such was not the case and of course when power went away so did its brains.
Naturally the guy that sold us the machine couldn't find his parameter sheet and had no download.
I have reloaded 10t controls before but not on an Ikegai.
I recently read a post here from July of 2017, that I can no longer find, from some folks that have exactly the information we need to get this machine running again.
If someone would please holler me up I would deeply appreciate it. email is [email protected]
We are in need of a base parameter list with Keep relay, PMC and whatever other voodoo this machine needs.
Thanks much.
Such was not the case and of course when power went away so did its brains.
Naturally the guy that sold us the machine couldn't find his parameter sheet and had no download.
I have reloaded 10t controls before but not on an Ikegai.
I recently read a post here from July of 2017, that I can no longer find, from some folks that have exactly the information we need to get this machine running again.
If someone would please holler me up I would deeply appreciate it. email is [email protected]
We are in need of a base parameter list with Keep relay, PMC and whatever other voodoo this machine needs.
Thanks much.