Richard/SIA
Cast Iron
- Joined
- May 13, 2007
- Location
- No. Nevada
Cincinnati Milacron 208U chucking lathe.
All I have is the very basic twelve page Getting Started booklet, Publication No. CTL-454-1
It fails to explain setting up threading in SFP.
I think there should be a more detailed manual available.
I recall seeing an old post here stating that someone had it on PDF.
If SFP works it would make my life a lot simpler.
When I tried it a few years ago it wanted to do the whole operation in a single pass and I never tried again.
No doubt I did not have something setup correctly.
I'm a bit more familiar with the Milacron 208U/Acramatic 850 now so want to try again once I have a better manual.
All I have is the very basic twelve page Getting Started booklet, Publication No. CTL-454-1
It fails to explain setting up threading in SFP.
I think there should be a more detailed manual available.
I recall seeing an old post here stating that someone had it on PDF.
If SFP works it would make my life a lot simpler.
When I tried it a few years ago it wanted to do the whole operation in a single pass and I never tried again.
No doubt I did not have something setup correctly.
I'm a bit more familiar with the Milacron 208U/Acramatic 850 now so want to try again once I have a better manual.