I have an Emco 220 with the TM02 control. Everything works but the spindle acts weird. It is on 3 phase not RPC. When the machine is started spindle sits still but after the 1st time the spindle is turned on it will not stop unless the power is shut off. E-stop doesn't do it reset doesn't do it. The spindle will only go down to ~ 500rpm when commanded to stop.
I am guessing there is a pot somewhere to adjust but I couldn't see where it might be. Can someone please help?
TIA,
Eric
I am guessing there is a pot somewhere to adjust but I couldn't see where it might be. Can someone please help?
TIA,
Eric