exkenna
Stainless
- Joined
- Nov 29, 2007
- Location
- North Alabama
Hooo-Weee! We're gonna have some fun now.
I am in need of a volunteer to run a new Feed-Mill tool. Parameters for low carbon steel are 200 inches per minute at .060 depth of cut, 1150 RPM.
It would be nice if we could video this but it's not mandatory. I'll make feed/speed adjustments based on your material and hardness.
Anyone down here in the southeast?
Thanks,
Curt
I am in need of a volunteer to run a new Feed-Mill tool. Parameters for low carbon steel are 200 inches per minute at .060 depth of cut, 1150 RPM.
It would be nice if we could video this but it's not mandatory. I'll make feed/speed adjustments based on your material and hardness.
Anyone down here in the southeast?
Thanks,
Curt