There are a lot of people here with a lot of knowledge, so I was hoping to get some help on this one.
I need to program an internal 3/8-18 NPT thread single point. I'm using a Fanuc OT control (two G76 lines). I have the machinist handbook, but I don't know where the numbers for the thread comes from.
I need to know the Dia. at the beginning (large ID) and the end of the thread (small ID), the length of thread, and the height of the thread. Where in the tables can I find these values?
Any and all help is much appreciated.
I need to program an internal 3/8-18 NPT thread single point. I'm using a Fanuc OT control (two G76 lines). I have the machinist handbook, but I don't know where the numbers for the thread comes from.
I need to know the Dia. at the beginning (large ID) and the end of the thread (small ID), the length of thread, and the height of the thread. Where in the tables can I find these values?
Any and all help is much appreciated.