U10 control:
Single point ID thread wants to taper up in X, instead of down in X.
Here's the meat of the program
G0 X.88 Z.3
G71 X1.003 Z-1.313 D.015 U.001 B60 A-1.7821 H.082 F.0714
G0 Z.1
As I stated, the taper wants to run the wrong way. This is an ID thread.
Thanks for any help.
Dean
Single point ID thread wants to taper up in X, instead of down in X.
Here's the meat of the program
G0 X.88 Z.3
G71 X1.003 Z-1.313 D.015 U.001 B60 A-1.7821 H.082 F.0714
G0 Z.1
As I stated, the taper wants to run the wrong way. This is an ID thread.
Thanks for any help.
Dean