My work has a Lagunmatic 250 with a Dynapath Delta control that has been sitting idle for at least 5 years. I fired it up today, and at one point even got it moving (x,y,z, and spindle rotating). It was turned off, and when I turned it back on, I could not get it to home back out. I follow the procedure in the manual, but when I try to reference zero and hit cycle start, it throws a fault that axis must be referenced. Any pros out there that can give me a pointer or 2?
<iframe width="480" height="360" src="http://s1259.photobucket.com/user/rbenne14/embed/slideshow/"></iframe>
<iframe width="480" height="360" src="http://s1259.photobucket.com/user/rbenne14/embed/slideshow/"></iframe>
Last edited: