Hi.
I would like to get my DNC up and running on my Dialog 4 and make a free solution available to everyone.
I have installed NCLink from OneCNC and it works well in mode 14.
Ross has been so kind as to send me the full program from the "FP3NC, Dialog 4. Transfer large programs" tread.
I can activate the upload from the PC. It waits for the Dialog 4 to get in DNC mode (awaiting handshake). When I activate DNC, the Dialog reports error 111 right away.
According to the error list and troubleshooting guide that Martin Peitz made available, error 111 means timeout. Weird as there is loads of data. It may mean that it expects something else.
Does any of you happen to know what might cause an error 111?
Does any of you use NCLink for DNC? I wonder if it will work with DNC.
Any clues?
/Torleif.
I would like to get my DNC up and running on my Dialog 4 and make a free solution available to everyone.
I have installed NCLink from OneCNC and it works well in mode 14.
Ross has been so kind as to send me the full program from the "FP3NC, Dialog 4. Transfer large programs" tread.
I can activate the upload from the PC. It waits for the Dialog 4 to get in DNC mode (awaiting handshake). When I activate DNC, the Dialog reports error 111 right away.
According to the error list and troubleshooting guide that Martin Peitz made available, error 111 means timeout. Weird as there is loads of data. It may mean that it expects something else.
Does any of you happen to know what might cause an error 111?
Does any of you use NCLink for DNC? I wonder if it will work with DNC.
Any clues?
/Torleif.