miburk
Aluminum
- Joined
- Jan 15, 2011
- Location
- Germany,35764 Sinn
I am facing the following things:
FP4MA with Contour 2
When i start the machine in BA5 i get the error FP01.
This is reproducable.
When i pull out the Board of the regulator for X-Axis i can switch on and drive the y/Z Axis.
When i pull out the Board of the regulator for Y/Z-Axis i can switch on and drive the x Axis.
This is without exchanging the regulator boards.
I exchanged both regulators and both Power Units for the axis , also the Power Supply 038035 to known working ones.
The error remains.
As the NRP53 deliveres the setpoints i also exchanged this. ERROR remains.
Now i am at a point where i dont have an idea what could cause the Error FP01 also.
Any ideas are welcome.
regards Michael
FP4MA with Contour 2
When i start the machine in BA5 i get the error FP01.
This is reproducable.
When i pull out the Board of the regulator for X-Axis i can switch on and drive the y/Z Axis.
When i pull out the Board of the regulator for Y/Z-Axis i can switch on and drive the x Axis.
This is without exchanging the regulator boards.
I exchanged both regulators and both Power Units for the axis , also the Power Supply 038035 to known working ones.
The error remains.
As the NRP53 deliveres the setpoints i also exchanged this. ERROR remains.
Now i am at a point where i dont have an idea what could cause the Error FP01 also.
Any ideas are welcome.
regards Michael
Last edited: