Lastuneste
Aluminum
- Joined
- May 17, 2012
- Location
- Helsinki, Finland
I get these alarms with almost every setup. To dial indicate tool holders, I have to spend a while moving the Z axis with door open (setup switch in "mode 2"). Similar thing occasionally happens when rotating C axis with door open. Is there a way to avoid these alarms OR clear them without turning off the entire control? I haven't been able to find a way around it.
The machine is a CTX Beta 800 running on Sinumerik 840D. Another 1250-series DMG also running 840D has had the same issue, but we don't dial holders on that machine so often.
The machine is a CTX Beta 800 running on Sinumerik 840D. Another 1250-series DMG also running 840D has had the same issue, but we don't dial holders on that machine so often.