I was wondering if anyone can give me a quick crash course on mill>endface>side in mapps/capps, I'm having a really hard time putting in the (what I think is correct) geometry.
I'm having trouble doing the .531 radius
Any help would be really appreciated thank you guys
Some years since i done this.. so maybe I get I wrong. but maybe I can help.
Maybe if you try this?
Start point at x-2y0? (I don't know the X because it's not on the drawing) (and I think the x is diameter?)
Start point. X-2y0
LINE UP .235/2
LINE RIGHT No input (because you what the capps to do the math)
CCW CIRCLE
Center x0y0
radius .531
No input on the enpoint
Where you can chose something about left? Rigth? This shall be left I think.
LINE RIGHT X2.Y.235/2
LINE DOWN TO Y0
I just did the half part. now you could use the mirror func or draw the rest
Its really hard to remember the circle screen.. so maybe I got it wrong there.
So I'm still having an issue with the radius, I did exactly what you said but the radius isn't showing up all it's doing is drawing what I've attached below, and then everything I try to draw after this gives me a contradiction error an I missing something here? And thank you for the reply
This website or its third-party tools process personal data (e.g. browsing data or IP addresses) and use cookies or other identifiers, which are necessary for its functioning and required to achieve the purposes illustrated in the cookie policy. To learn more, please refer to the cookie policy. In case of sale of your personal information, you may opt out by sending us an email via our Contact Us page. To find out more about the categories of personal information collected and the purposes for which such information will be used, please refer to our privacy policy. You accept the use of cookies or other identifiers by closing or dismissing this notice, by scrolling this page, by clicking a link or button or by continuing to browse otherwise.