pri0ritize
Aluminum
- Joined
- Mar 3, 2014
- Location
- Poulsbo, WA
Hello again.
I finally got my MV-35 moved and set in place. It was quite the adventure. I'm to the point of hooking power to the machine and I want to ensure that I don't damage it in doing so. Reading the manual it states that power should be 200V/220V with a variance of 10%. This can get me as high as 242 and as low as 198 if I'm using 220V (as long as my math hasn't failed me), I've read in other forum posts that other Mori machines need to be within 2-4% of each other on each leg and I want to ensure that this isn't the case. Have any of you run an MV-35 on a phase converter that has a wild leg?
I finally got my MV-35 moved and set in place. It was quite the adventure. I'm to the point of hooking power to the machine and I want to ensure that I don't damage it in doing so. Reading the manual it states that power should be 200V/220V with a variance of 10%. This can get me as high as 242 and as low as 198 if I'm using 220V (as long as my math hasn't failed me), I've read in other forum posts that other Mori machines need to be within 2-4% of each other on each leg and I want to ensure that this isn't the case. Have any of you run an MV-35 on a phase converter that has a wild leg?