Hello all.
I’m currently trying to program a 240cc to do several profiles. As it stands I’ve created a multi-prog to do 4 profiles using the ct expert and have then altered this program to suit my subprogram using m99. However when I try to draw out my program it draws out the profiles on top of each other (see image attached) ignoring the points that I set earlier (using sep,cp1 etc.) Where am I going wrong? Is it necessary to set my stored points in the variables page?
Thanks in advance to any help.
Image
I’m currently trying to program a 240cc to do several profiles. As it stands I’ve created a multi-prog to do 4 profiles using the ct expert and have then altered this program to suit my subprogram using m99. However when I try to draw out my program it draws out the profiles on top of each other (see image attached) ignoring the points that I set earlier (using sep,cp1 etc.) Where am I going wrong? Is it necessary to set my stored points in the variables page?
Thanks in advance to any help.
Image