Hello!
My Cut 200 have trouble threading the wire through the small part that is rolling up the wire in the upper head when wire break occurs. I suspect that is because the alignment of that part is not straight but in an angle.
Are there any system parameters or manual alignment to set the correct position?
I attach pictures for better understanding.
Thanks for the answers:
Mate
My Cut 200 have trouble threading the wire through the small part that is rolling up the wire in the upper head when wire break occurs. I suspect that is because the alignment of that part is not straight but in an angle.
Are there any system parameters or manual alignment to set the correct position?
I attach pictures for better understanding.
Thanks for the answers:
Mate