Agiecut 100D startron

Agiecut beginner · Feb 1, 2017

Dear All,
We have an old Agiecut 100D EDM, and have an error:
493 system not set up for startron
What I checking out?
Thanks

agieman · Feb 6, 2017

question 1. do you have startron on the machine? it is a hole popper mounted behind the lexan door above the worktank

Agiecut beginner · Feb 7, 2017

Hi Agieman!
I think, there's nothing there.
What is the function?

agieman · Feb 7, 2017

You do NOT have startron on the machine. it was an integrated hole popper. Open the back of the CD cabinet. Look for a series of small wire wrapped jumpers on the upper 1/2 of the big back board. make sure they are good. One of those jumpers tells the machine if startron is on the machine.

Agiecut beginner · Feb 7, 2017

Many thanks Agieman.
I'm going to find jumper.

...
The jumpers:

Which of the jumper?

agieman · Feb 8, 2017

you found the jumpers. was it working before? if so, look for a loose jumper i'm not sure which one.

Agiecut beginner · Feb 9, 2017

We bought in this state. The machine is still not working here.
I will checking jumpers.
Thanks

Search

Largest Manufacturing Technology Community on the Web

Search

Agiecut 100D startron

Agiecut beginner

Plastic

agieman

Cast Iron

Agiecut beginner

Plastic

agieman

Cast Iron

Agiecut beginner

Plastic

agieman

Cast Iron

Agiecut beginner

Plastic

Similar threads