toolnuts
Cast Iron
- Joined
- Sep 27, 2009
- Location
- washington
My Robofil 510F cut function is not working.
I just watched the "cut" function in action - it starts by feeding wire, then stops,
and very slowly reverses (it may do that twice, but I don't remember), then the wire
cuts, and the wire quickly reverses, and the wire retracts into the anneal tube.
I checked the idler/feed arm in the wire cabinet, and it was in the full down position, so
it must have provided the force to quickly reverse the wire direction into the
anneal tube.
What is suppose to hold the wire in place after the "cut" process so it doesn't
retract into the anneal tube?
Your help is appreciated.
Paul
I just watched the "cut" function in action - it starts by feeding wire, then stops,
and very slowly reverses (it may do that twice, but I don't remember), then the wire
cuts, and the wire quickly reverses, and the wire retracts into the anneal tube.
I checked the idler/feed arm in the wire cabinet, and it was in the full down position, so
it must have provided the force to quickly reverse the wire direction into the
anneal tube.
What is suppose to hold the wire in place after the "cut" process so it doesn't
retract into the anneal tube?
Your help is appreciated.
Paul