What's new
What's new

CUT20 P problem

VictorStefan

Plastic
Joined
Oct 18, 2017
Hello everyone,
I have a problem with my machine, Aggie Charmille Cut 20P
I have a error "[E20106]:clean reservoir water level is low". I searched in the manual, but it only say to check the water level (wich is ok) and the water circuit system-> here i have a problem, i dont know what and how to check.
Also, i saw that i have no circulation on the resin reservor (there are 2 hose there)
 
there is a float switch in the clean tank that is failing or a hose or flow is hitting float triggering alarm. That or wiring is bad. Find float switch it is in a grey block with conductivity probe.
 
yes sir. if you go int diagnostic you can see if they actuate. or check in the white junction box mounted over the pumps the one with lots of wires sticking out the bottom.
 








 
Back
Top