been having some issues with the EDM sparker some how its forgets where the part position is,I don't understand why this happens as its not all the time. I would spark a job, check the depth of the job. I haven't moved the part from fixture or moved the electrode. I'll go back to the EDM settings and only alter the depth(nothing else), run the job and its 2 or 3 mill off position resulting in a mismatch.
I noticed on some occasions, i'll do a reference ball measure with the probe, probe the part. measure tool offset. Then when I run the job it sometimes it is a mile away from the job am I'm like hmmm. when I say a mile the electrode thinks the job is on the opposite side of the part, and im like hmmmm really! to me it looks like a software issue, I wonder if anyone else has experienced this problem
I noticed on some occasions, i'll do a reference ball measure with the probe, probe the part. measure tool offset. Then when I run the job it sometimes it is a mile away from the job am I'm like hmmm. when I say a mile the electrode thinks the job is on the opposite side of the part, and im like hmmmm really! to me it looks like a software issue, I wonder if anyone else has experienced this problem