Shepard1967
Plastic
- Joined
- Feb 8, 2008
- Location
- Florida
Hello,
I managed get an Agie 100D and have just set it up and have it moving. It is my first edm. I'm trying to figure out the cut file. I can move the axis around the geometry but don't know the settings or codes for the pre and post geometry commands such as autothreading or powersettings. I attached a dxf and am hoping someone has the time to show me an example to get me started.
The material is 6061 Al, the cavity is 2.75in deep and I'm using .01 brass wire.
Any help would be greatly appreciated, Shepard
I managed get an Agie 100D and have just set it up and have it moving. It is my first edm. I'm trying to figure out the cut file. I can move the axis around the geometry but don't know the settings or codes for the pre and post geometry commands such as autothreading or powersettings. I attached a dxf and am hoping someone has the time to show me an example to get me started.
The material is 6061 Al, the cavity is 2.75in deep and I'm using .01 brass wire.
Any help would be greatly appreciated, Shepard