Bradracer18
Aluminum
- Joined
- Feb 9, 2012
- Location
- central, USA
Looking at getting a Mits MV2400 wire edm, we currently run a Mits FX10k. I know the technology will be much different, but is there anything worth noting? We are going to purchase the MV2400, so as little down time as possible will be nice if anyone can help me out. Its my understanding that the machine is conversational and can be programmed at the machine.
We are going to switch from running .010 to .012. Hopefully this will be a good thing. We do a lot of rough cutting or rough cutting with 1-2 skims. We also do 3 skims too but maybe not quite as often.
I'm excited to get something where I can cut on it, shut it down and then come back the next day and start right up again. The previous machine didn't have a cooler, so stopping had to be planned in a certain place.
Going to dabble in the rails/fixturing world on this edm, so that will be new to me also. I hope we can find a way to make everything we cut work.
We are going to switch from running .010 to .012. Hopefully this will be a good thing. We do a lot of rough cutting or rough cutting with 1-2 skims. We also do 3 skims too but maybe not quite as often.
I'm excited to get something where I can cut on it, shut it down and then come back the next day and start right up again. The previous machine didn't have a cooler, so stopping had to be planned in a certain place.
Going to dabble in the rails/fixturing world on this edm, so that will be new to me also. I hope we can find a way to make everything we cut work.