What's new
What's new

Question on WEDM on switch back and forth between Diamon guides ,etc,etc

Nc_coder

Plastic
Joined
Dec 16, 2013
Location
Midwest
I am constantly doing many jobs from no taper up to 30 dg back to back. If I leave the larger jet nozzle,angle master diamond guides and flush cups to no tapers will this sacrifice accuracy? Please keep in mind most of the stuff I run through here close is usually good enough :).

On a side note I am using a Mitsubishi MD Pro III.

Thanks,

Nc_coder
 
I would just put the threading jet nozzle in for threading when not cutting steep tapers. I do believe the guides for steep taper have extra clearance but depending on the tolerance of what you're cutting I leave the steep taper guides In depending on work load and flow .also put the normal flush caps.
 








 
Back
Top