ronaldinho_07
Aluminum
- Joined
- May 23, 2016
- Location
- VietNam
Hello you guys.
I am not a wedm guy,i do not have wedm either.but i need to cut alot of piecut.
I send the Titanium grade 2 tubing for wedm to cut into thousand pieces.
The problem is
He used the same setting as he used on steel,wire was broken 3-4 times a day.
But when cutting steel,wire may last for a week.
So which setting should be adjusted for decreasing wire break rate ?
Thank you guys.
by the way,he uses molypdenum wire
I am not a wedm guy,i do not have wedm either.but i need to cut alot of piecut.
I send the Titanium grade 2 tubing for wedm to cut into thousand pieces.
The problem is
He used the same setting as he used on steel,wire was broken 3-4 times a day.
But when cutting steel,wire may last for a week.
So which setting should be adjusted for decreasing wire break rate ?
Thank you guys.
by the way,he uses molypdenum wire