dfw5914
Stainless
- Joined
- Apr 1, 2006
- Location
- Sanctuary, TX
I just bought this old Airco welder/generator model 2.25A/DDG-AMEL-A. It is powered by an Onan CCK-MS/736F (I was told 20HP, which I strongly doubt) two cylinder.
Inside the side cover it says Miller Gold Star, so I believe this was sourced from Miller (did Airco buy all their stuff from Miller?). I am trying to find out if there was an identical model sold by Miller, in hopes of getting a operators manual for it.
The closest I've found was an older Miller AEAD, the chassis looked almost identical but the front panel was quite a bit different.
On Edit: An AEA-200L is also very similar. Again, with a different front panel.
Anyone recognize this welder?
Inside the side cover it says Miller Gold Star, so I believe this was sourced from Miller (did Airco buy all their stuff from Miller?). I am trying to find out if there was an identical model sold by Miller, in hopes of getting a operators manual for it.
The closest I've found was an older Miller AEAD, the chassis looked almost identical but the front panel was quite a bit different.
On Edit: An AEA-200L is also very similar. Again, with a different front panel.
Anyone recognize this welder?
Last edited: