scadvice
Titanium
- Joined
- Jan 16, 2009
- Location
- "Stuck in Lodi", Ca
Anyone ever cut Delrin (Acetal) sheets (.01" thick)? I have an inquiry to do some special gaskets but my laser is in the middle of me installing a new cooling system so I can’t even do a test run. I know it will cut OK, I don't recall things like edge finish and detail of small features or how color effects the cut.
I could do them on the mill with a plate fixture but the laser would be so much faster and the mill would be a much higher bid cost with all the detail on these parts. The laser will be up and running in plenty of time before the parts were due.
Trying to estimated things out here before sending in bid.
I could do them on the mill with a plate fixture but the laser would be so much faster and the mill would be a much higher bid cost with all the detail on these parts. The laser will be up and running in plenty of time before the parts were due.
Trying to estimated things out here before sending in bid.