Jim S.
Hot Rolled
- Joined
- Sep 4, 2003
- Location
- South Carolina
I was just given a PowCon 400SM welder and would appreciate a source for an instruction manual.
My first requirement is to properly connect the primary for 230 single phase so if anyone knows that scheme, it will ge greatly appreciated. It appears to be currently set for 230 3 phase based on the plug and some hand writing on the case. Presumably it works but I'd like to check it out before investing much in it.
PowCon gets good reviews from my reading on this site and others, except for sole-source repair and high parts prices. I understand the unit will be derated on single phase but I doubt I'll ever need more than 150 amps.
Regards,
Jim
My first requirement is to properly connect the primary for 230 single phase so if anyone knows that scheme, it will ge greatly appreciated. It appears to be currently set for 230 3 phase based on the plug and some hand writing on the case. Presumably it works but I'd like to check it out before investing much in it.
PowCon gets good reviews from my reading on this site and others, except for sole-source repair and high parts prices. I understand the unit will be derated on single phase but I doubt I'll ever need more than 150 amps.
Regards,
Jim