pheyden
Plastic
- Joined
- Dec 24, 2004
- Location
- Raleigh NC
I have to make several tapered spacers, one with a 2.364 in/ft taper, and the other with a 2.691 in/ft taper. As I do not have a taper attachement, and the holes are only 1" deep, so I plan to use a boring bar in the compound slide. As this is graduated in degrees, I need to convert inch/foot taper measurements to included angle taper measurements.
I googled for a conversion formula, but was unsuccessful. Can anyone assist?
Thanks
Paul
I googled for a conversion formula, but was unsuccessful. Can anyone assist?
Thanks
Paul