We have a job that requires a nut to be spun down on a 1/2-13 x 5" eye bolt, the nut will be hand held hence low torque needed. can you think of any pneumatic motors I could mount to a table. we have to do about 2500 to 5000 of these at a time, so speed is important.
Before I got there they would start the threads and spin them down by hand. I went and grabbed a couple 3/8" drills and some 1/4" round and bent a hook in it, set the clutch on the drill to lightest setting and hooked the eye through the rod and spun them down. Made the job quite a bit faster.
I would like to find something that spins up fast but stalls before ripping off a hand or jamming the threads up.
Thank you for reading and your spit balling is appreciated.
Before I got there they would start the threads and spin them down by hand. I went and grabbed a couple 3/8" drills and some 1/4" round and bent a hook in it, set the clutch on the drill to lightest setting and hooked the eye through the rod and spun them down. Made the job quite a bit faster.
I would like to find something that spins up fast but stalls before ripping off a hand or jamming the threads up.
Thank you for reading and your spit balling is appreciated.