I would like to refurbish a monoblock carb by boring the slide area and fitting a sleeve to the slide. I found some old threads mentioning this process but how were the carb bodys held for boring?
The monoblock has a hole straight through from the slide area and I asusmed this was concentric. I made an arbor to hold the carb by that through hole but it runs out by 1/16" or so when spinning on a lathe. I am not sure what else to use as a datum/ holding point.
The monoblock has a hole straight through from the slide area and I asusmed this was concentric. I made an arbor to hold the carb by that through hole but it runs out by 1/16" or so when spinning on a lathe. I am not sure what else to use as a datum/ holding point.