Ray Behner
Diamond
- Joined
- Mar 27, 2009
- Location
- Brunswick Oh USA
Just thought I'd ask, to see what (if any) responses there are. It's somewhat slow for say a 5'' hole. Probably .100 per minute, but it cuts a nice hole and is easy to control. Had these 1/2'' plates to bore to size, so I first used this tool to cut undersize. Never used the pilot bit. Don't see a need for it, unless you need to flip the piece over. Mine is a 3 MT shank and will cut 12''. Never cut bigger than 8.875 for a 9'' bore job, but I think a 12'' would do fine also.