What's new
What's new

Material source needed 1/16 x 3/4 flat bar

Joined
Dec 26, 2006
Location
NJ
I looked for the subject material in McMaster Carr and speed metals. Nada...just need to fab up a little weldment that is turning in a PIA!!!!
 
My thoughts are that it's sheared sheet metal and not barstock. Which is a good thing if you need to do any bending as a lot of cold rolled barstock you get these days just breaks.

So I'd probably hit up a local fab shop for a couple strips. But not an HVAC shop as that would probably all be galvanized.
 
for the small quantities I use,I order it from MSC or Fastenal they are not the best priced but they are quick and handle small quantities.
 








 
Back
Top