adh2000
Titanium
- Joined
- Dec 21, 2005
- Location
- Waukesha, WI
I've got a Baker electric forklift B-70CE with some annoying electrical problem. If I raise the forks while driving forward or back the forklift stops. The forks continue to raise and the hydraulics continue to work fine but it won't go forward or backwards. Turning the key off and on again has no effect. So far the only thing that will make it drive again is to unplug the battery and plug it back in. Then everything works normally again. Very annoying as I'm used to adjusting the forks up or down a little as I drive up to a load. Now I have to stop first, adjust the forks up a little, then go again which I suppose isn't that big a pain but I keep forgetting that I have to stop first before raising the forks. Other forklifts I own have never had this problem (feature?).
One other weirdness. Just sitting everything is quiet of course. When I put the drive lever forward or reverse I can hear the steering pump start, which makes sense because it thinks you are getting ready to drive. But I also hear the steering pump start if I touch the brake pedal. Not really a problem just doesn't seem correct.
Anyone have either of these problems? Source for a schematic? I've pulled the floor boards up and looked around for shorted or loose wires with no luck.
Alan
One other weirdness. Just sitting everything is quiet of course. When I put the drive lever forward or reverse I can hear the steering pump start, which makes sense because it thinks you are getting ready to drive. But I also hear the steering pump start if I touch the brake pedal. Not really a problem just doesn't seem correct.
Anyone have either of these problems? Source for a schematic? I've pulled the floor boards up and looked around for shorted or loose wires with no luck.
Alan