Ray Behner
Diamond
- Joined
- Mar 27, 2009
- Location
- Brunswick Oh USA
Video-Cutting 5'' hole with Val-Cut trepanner
Had a pile of 3/8 plates that needed a 5'' hole. Thought I'd show you the last .100" of the cut with a Val-Cut. It bird nests pretty good, but doesn't interfere with the cut. This is about 180 rpm. Takes about 2½ / 3 minutes per piece.
Val-Cut trepanning 5'' hole - YouTube
Had a pile of 3/8 plates that needed a 5'' hole. Thought I'd show you the last .100" of the cut with a Val-Cut. It bird nests pretty good, but doesn't interfere with the cut. This is about 180 rpm. Takes about 2½ / 3 minutes per piece.
Val-Cut trepanning 5'' hole - YouTube
Last edited: