WizardOfBoz
Diamond
- Joined
- Sep 30, 2006
- Location
- SE PA, Philly
My Emerson Electric drill press has a compression fitting to hold the table to the mast, but does not have any handle or crank (or rack gear, for that matter) to lift the table up or down.
I can loosen the clamp and move the table manually, but this is not efficient. Is there an aftermarket device that I can attach to the unit? I seem to recall a device that involved stretching a motorcycle chain from the the top of the mast to the bottom, and a worm-gear deal attached to a crank attached to the table.
Thanks for any help, Jim
I can loosen the clamp and move the table manually, but this is not efficient. Is there an aftermarket device that I can attach to the unit? I seem to recall a device that involved stretching a motorcycle chain from the the top of the mast to the bottom, and a worm-gear deal attached to a crank attached to the table.
Thanks for any help, Jim