Rick Rowlands
Titanium
- Joined
- Jan 8, 2005
- Location
- Youngstown, Ohio
I have a DC mill motor that has a 2" shaft that tapers down to 1 11/16" over 3 5/16" length. At the end of that is 1 1/2" of 1 1/4 x 7 threads. These motors are used in steel mill service and overhead cranes, actually one end of this motor has a brake wheel attached.
I need to find a source where I can purchase a hub that would fit this shaft. I have to make up a handwheel so I can manually turn the mechanism that this motor would turn. The mechanism rotates the vessel on a hot metal car that was recently acquired by our museum project.
If I cannot locate a source for the hub is there anyone who could machine one for me?
I need to find a source where I can purchase a hub that would fit this shaft. I have to make up a handwheel so I can manually turn the mechanism that this motor would turn. The mechanism rotates the vessel on a hot metal car that was recently acquired by our museum project.
If I cannot locate a source for the hub is there anyone who could machine one for me?