Bob Looney
Aluminum
- Joined
- Dec 6, 2006
- Location
- USA
Has anybody seen this before? These were anodized and the pattern came thru as a bright grey, rest of the part was the std. dark grey. They were then stripped, top surface was re machined an a cpl parts and re anodized. The pattern came thru again.
Looking at the stripped parts, the pattern can be seen going thru the mtl. It appears to be some sort of inclusion in the bar stock as the pattern repeats thru all the parts.
The parts are oriented in the vises by the saw cuts so the pattern repeats in basically the same spots on the parts.
Looking at the stripped parts, the pattern can be seen going thru the mtl. It appears to be some sort of inclusion in the bar stock as the pattern repeats thru all the parts.
The parts are oriented in the vises by the saw cuts so the pattern repeats in basically the same spots on the parts.