Bill D
Diamond
- Joined
- Apr 1, 2004
- Location
- Modesto, CA USA
I may have some bad information but. On a 13" Harrison lathe there is a 12mm? threaded hole for a evebolt to lift the entire machine. Looking online an eyebolt of that size is rated at about 600-880 pounds, I forget the exact conversion. Problem is the lathe weighs at least 1,300 -1,500 pounds. What am I missing here? Are there supposed to be some other lift points at the same time?
Bill D.
this may be the reason that the threaded hole was dropped in latter years
Bill D.
this may be the reason that the threaded hole was dropped in latter years