Rudd
Stainless
- Joined
- Jul 30, 2003
- Location
- savannah, jaw-ja
We have a job where a fix is to install (2) 6" x 6" x 9' stainless steel tube columns. Architect would like a "better than matte" finish, hopefully somewhat reflective. I suggested going at it with a belt sander with successivly finer grits, ending up about 600 grit, which I think would be a matt finish, from there, I dunno.. buffing?
Time, as in change order money, is an issue. Any thoughts on time or method of getting from matte to "somewhat reflective"?
It's 303 stainless as I recall.
thanks in advance
Rudd
Time, as in change order money, is an issue. Any thoughts on time or method of getting from matte to "somewhat reflective"?
It's 303 stainless as I recall.
thanks in advance
Rudd